SQA National 5 Graphic Communication 2D graphic communication overview quiz quiz
16questions. Pick an answer and you'll see why right away.
In third-angle projection, where is the plan placed relative to the front elevation?
Which two dimensions does the front elevation show?
What does a thick continuous line represent on a British Standards drawing?
What does a thin dashed line show?
Which line type is a long-dash, short-dash, long-dash pattern used as a centre line?
Which symbol must be written before a diameter dimension?
A shaft is dimensioned 30 with a tolerance of plus or minus 0.2. What is the largest acceptable diameter?
Where should the figure be placed on a horizontal dimension line according to British Standards?
On a sectional view, how is the cut material shown?
Which feature is conventionally NOT hatched even when the cutting plane passes along it?
What is the purpose of an assembly drawing?
On an assembly drawing, what identifies each separate component?
Which building drawing shows the room layout of one storey viewed from above?
A floor plan is drawn at a scale of 1:50. A wall measures 60 mm on the drawing. What is its true length?
Why do building drawings use a scale?
Why do technical drawings follow British Standards conventions?