Skip to main content

← back to the guide

SQA Higher Engineering Science Area 2 Electronics and control overview quiz quiz

16questions. Pick an answer and you'll see why right away.

  1. Which best describes an analogue signal?

  2. In which order does the universal system model run for an electronic device?

  3. Two 4 ohm resistors are connected in parallel. What is the total resistance?

  4. Which power relationship should you use when you know only the current and the resistance?

  5. In a potential divider, the voltage across one resistor is the supply voltage times

  6. How does the resistance of a thermistor change as its temperature rises?

  7. An LDR is in a circuit. How does its resistance change as it gets darker?

  8. An inverting amplifier has a feedback resistor of 100 kilohms and an input resistor of 25 kilohms. What is the gain?

  9. An op-amp comparator has no feedback resistor. When does its output saturate high?

  10. What controls whether a transistor used as a switch is on or off?

  11. Why is a diode connected across a motor switched by a transistor?

  12. When does a two-input AND gate output a logic 1?

  13. A two-input NOR gate has inputs A = 0 and B = 0. What is its output?

  14. A combinational logic output is (A AND B) OR C. For A = 1, B = 0, C = 1, what is the output?

  15. An LED needs 2.0 V at 10 mA from a 5 V supply. What series resistor is required?

  16. Why is an output device such as a motor interfaced to a logic output through a transistor?